IIoT vs IoT Explained

It's easy to get lazy, or just make a mistake, when using TLAs (Three Letter Acronyms) and technical jargon. I know that I am guilty of using IoT vs IIoT almost interchangeably or without distinction. There is a difference and this article from LNS RESEARCH explains those differences in detail.  The Venn diagram below is a very helpful visualization.
Courtesy of LNS Research. All rights reserved.

Comments

Post a Comment

Popular posts from this blog

IoT and Asset Performance Management - a short story

Image
One of the key use cases for IoT is in the area of machine and asset performance monitoring. One of my last projects was to have 125 NC (numerically-controlled) machines connected with real-time performance monitoring across 5 different locations in North America. The goal was to better understand their use, but also the down-time with a key focus on the reasons behind those lost hours. Some management folks saw this as an opportunity to monitor, and then improve, operator performance. The truth of the matter is that there were bigger savings to be found by solving the problems that kept the machines out of productive use. The article that follows is a simple narrative that comes to the same conclusion but using an example everyone can relate to. My experience also reflects their findings. Enjoy the article:  https://tulip.co/blog/uncategorized/dishwasher-asset-performance-management/ Source: IHS Markit, DOE “Human Performance Improvement Handbook”, Noria research
Read more

The Rise of the Connected Worker

Image
LNS Research publishes very good, timely and relevant articles on a variety of manufacturing- related topics. A current article is about the trends driving "connected worker" initiatives. Most definitely an aging workforce needs to be a major consideration. Companies are losing significant talent due to retirement. What they may not realize, is the "tribal knowledge" that leaves with those workers. Over the years, people have learned/discovered ways to get the job done that is often not documented in engineering drawings, manufacturing engineering process sheets, standard operating procedures, and all the other means of internally communicating process information. Ideally, companies would work with senior employees to ensure that information is captured before departure. Process audits are one way to do this. In my opinion, a better way is to have someone watch and document the training of new/newer employees by those who are planning on retiring. The provides di
Read more